Festo DW Serie Notice D'utilisation page 3

DW..-...
1 2 3
Warning
Danger of injury from parts flying around! The adjusting screws 1 and 3 are under
pressure in the case of pressurized DW. Adjusting screws that are unscrewed com-
pletely can be hurled out and result in serious injuries.
• Make sure that adjusting screws 1 and 3 are never completely unscrewed
(max. unscrewed length Lmax, see table).
Size
Lmax [mm]
Tab. 1
Note
• On delivery: The cushioning adjusting screw 3 "C" and the speed adjusting screw
1 "S" are unscrewed two thread revolutions.
• Setting the speed and cushioning:
Loosen lock nut and set the desired end location cushioning and speed with an in-
ternal hexagon screwdriver.
After setting, the screws must be secured again with the lock nut (tightening torque:
2 Nm).
• The supply port 2 and 4 can be revised by replacing the blanking plugs.
Festo – DW..-... – 1301a English
4
50 63
13 13
1
Adjusting screw "S" for speed
2
Supply port
3
Adjusting screw "C" for end position
cushioning
4
Supply port (sealed)
80
17
3