Festo ELGA-TB-G Notice D'utilisation page 34

ELGA-TB-G/-KF/-RF
Interfaces for mounting components
On the cover
e.g. with foot mounting HPE
1) è www.festo.com/catalogue
Fig. 8
Note
Danger of screws being pulled out, if the axis is only mounted to the covers and
the torque load around the longitudinal axis is too great.
• If there is high loading, mount the axis on the profile with additional mounting
components.
• Select mounting components or accessories (è www.festo.com/catalogue).
• Mount the mounting components outside the positioning range (avoid collisions).
• Tighten screw down firmly on cover.
Size
Screw (cover)
tightening torque
Tab. 1
• In the case of mounting accessories, comply with the tightening torque specified in the associated
product information.
5.1.2 Mount attachment components
Prerequisites
Note
A warped attachment component bends the slide
and shortens the service life of the guide.
• Use an attachment component with an even
surface.
Flatness:
– ELGA-TB-G:
– ELGA-TB-KF: t = 0.01 mm
– ELGA-TB-RF: t = 0.01 mm.
34
On the profile
1)
e.g. with slot nuts NST
70
M5
[Nm] 5.9
t = 0.03 mm
On the profile
1)
e.g. with profile mounting MUE
80 120/150
M5 M6
5.9 9.9
Fig. 9
Festo – ELGA-TB-G/-KF/-RF – 1512d English
1)
M8
24
t