Electrical Connection; Sources Of Danger; Danger Of Burns; Danger Of Fire - CASO DESIGN One Touch Cordless Vacuum Sealer Manuel D'utilisation

Warning
Please note that changes or modifications of this product is not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
Please note
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
► Reorient or relocate the receiving antenna.
► Increase the separation between the equipment and receiver.
► Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
► Consult the dealer or an experienced radio/TV technician for help.

2.2 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.

2.3 Sources of danger

2.3.1

Danger of burns

Danger
The sealing bar gets very hot. Please observe the following safety notice in order not to
burn yourself or others.
► To avoid getting burned, never touch the sealing bar directly after sealing process.
2.3.2

Danger of fire

Danger
There is a danger of fire due to the event the device is not used properly. Observe the
following safety notices to avoid dangers of fire:
► Do not set up the device near flammable material.
► Keep this appliance away from sources of heat (gas, electric, burner, heated oven).
6