Pentair RO-2500 Instructions D'utilisation Et D'installation page 13

3 - OPTIONAL INSTALLATION
Materials required (available from your local hardware store)
• 0.635 cm x 0.635 cm x 0.952 cm (1/4" x 1/4" x 3/8") compression or quick-connect tee
E
• 3 m (10 feet) of 0.952 cm (3/8") polyethylene tubing
• Shut-off valve
N
1. Turn off refrigerator water supply and icemaker (consult manufacturer's guidelines).
2. Close tank valve (on top of storage tank).
G
3. Turn off water to RO system at the cold water supply.
L
4. Open drinking water faucet to relieve pressure.
4.
5. Locate tubing (permeate) leading to your drinking water faucet. Cut and insert the 0.635 cm x 0.635 cmx
I
0.952 cm (1/4" x 1/4" x 3/8") compression or quick-connect tee into the permeate tubing. Consult
S
manufacturer's guidelines before installing the supply adapter.
H
NOTE: When cutting the permeate tubing, you may experience some water leakage.
6. Using a length of 3/8" polyethylene tubing, connect the icemaker/dispenser line with the free port on the
compression tee.
7. The shut-off valve should be installed as close to this port of the tee as possible. Shut-off valve should be
installed in the OFF position.
Consult manufacturer's guidelines before installing the shut-off valve.
8. Completely open cold water supply.
9. Open tank valve.
10. Turn off the drinking water faucet.
11. Turn on water to RO system at cold water supply.
12. Turn on icemaker and open shut-off valve. Consult manufacturer's instructions.
13. Check for leaks and tighten connections if necessary.
12