Anleitung_NTS_1725_L_SPK7:_
4. Important information
Please read the directions for use carefully and
observe the information provided. It is important to
consult these instructions in order to acquaint
yourself with the machine, its proper use and safety
precautions.
The corresponding safety information can be found
in the enclosed booklet.
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Achtung
Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation
nach EN 60825-1
Laser Klasse 2
1894S-8x11
Ï: 650 nm
P: ≤ 1 mW
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
A laser pointer is not a toy, and should be kept
out of the reach of children. Irreparable eye
damage can be done if the tool is used
improperly.
Any manipulation of the laser to enhance
performance is prohibited. Any damage done by
not following the safety instructions will not be the
liability of the manufacturer.
12.07.2010
8:02 Uhr
Seite 17
Noise emission values
Sound and vibration values were measured in
accordance with EN 61029-1.
L
sound pressure level
pA
K
uncertainty
pA
L
sound power level
WA
K
uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
5. Technical data
AC motor
Power P
Idle speed n
Carbide saw blade
Number of teeth
Bench size
Table width extension, left/right
Table length extension, rear
Cutting height max.
Height adjustment
96,2 dB(A)
109,2 dB(A)
230 V
S6 40% 1700 W
4800 min
0
Ø 250 x Ø 30 x 2.8 mm
626 x 445 mm
626 x 250 mm
445 x 320 mm
73 mm/90°
53 mm / 45°
infinite 0 -73 mm
GB
3 dB
3 dB
50Hz
-1
24
17