Jennair JBSFS42NMX Mode D'emploi page 28

2. Lower the panel bracket down onto the adjustment
pins at the top of the door.
A. Door panel
B. Mounting bracket
3. Repeat steps 1 through 2 to install the second door
panel.
4.
Using slotted hex-head screws (provided with
refrigerator), attach the mounting bracket (factory
installed), located at the bottom of the refrigerator
and freezer doors, to the respective door panels. Do
not fully tighten the screw.
A
A. Bottom hinge
INSTALL TOP GRILLE PANEL
B
A. Top grille panel
B. Cabinet sides
A B
C
C. Adjustment pins
B
B. Mounting bracket
A B
STANDARD INTEGRATED GRILLE
INSTALLATION—FLUSH GRILLE
1.
Hook the panel brackets onto the mounting bolts
extending from the top of the refrigerator.
A. Panel brackets
B. Grill trim piece
2. Pull the grille panel down slightly to lock into place.
Fully Integrated Grille Installation—Full Height Grille
1. Align the bracket on each side of the top grille panel
with the mounting bolts.
2. Push the grille panel forward until the bracket snaps
into place.
DOOR SWING ADJUSTMENT
It may be necessary to adjust the swing of the door. Make
sure the refrigerator door(s) can open freely. If the door(s)
opens too wide, install the door stop pin (provided with
refrigerator).
1.
Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole
shown.
3. Using a 5/32" hex key, tighten the door stop pin.
A. Door stop pin hole
A
B
A
28