Jennair JBSFS42NMX Mode D'emploi page 27

NOTE: Start with the screws in the center of the slots
as shown, then move the door panel, as necessary, to
align.
A
A. Door panel
B. Mounting bracket
Top Grille Panel
1.
Using the slotted hex-head screws (provided with
refrigerator), attach a mounting bracket to each side
of the top grille panel.
IMPORTANT: See the "Parts Provided" section to
select the brackets designated for your installation.
Use the Integrated Grille brackets for a Fully
Integrated Grille installation with a full height
grille.
Use the Standard Grille brackets for a Standard
Integrated Grille Installation with a closed or open
soffit.
A. Top grille brackets
B. White, grille trim piece
(taped to refrigerator door)
2. Using round-head screws (provided with refrigerator),
attach the grille trim piece to the bottom of the grill
panel.
NOTE: The grille trim is preinstalled on the panel kits.
27
B
A
B
REMOVE TRIM PIECES
1. Remove all tape and door bracing from the
refrigerator and freezer doors.
2.
Open the refrigerator and freezer doors.
3. Remove the hinge cover pieces from the top and
bottom of the door to expose the holes in the hinges.
A
A. Hinge cover pieces
INSTALL DOOR PANELS
IMPORTANT: Use the foam packaging to prop and hold
the door(s) open while installing a door panel.
1. Align the two shoulder washers, on the back of the
door panel, with the "J" slots on the side of the
refrigerator door. Slide the panel onto the door.
A
A. Shoulder washer and hex head pointed screw
B. "J" pocket
A
A
B