Beper 90.493A Manuel D'instructions page 19

Bread Maker Use instructions
This starts and stops or finishes the selected baking program.
Start
In order to start a program, press the "start/stop" button for approx 1 second. A short beep is heard
and the two dots in the time display begin to flash and the program starts.
Stop
In order to stop a program, press the "Start/Stop" button for approx 2 seconds until a been confirms
that the program has been switched off.
On/Off
Two dots flashing: Program is started.
Two dots continuously lit: Program is stopped.
Delay Timer
You can delay the time your bread maker starts to have fresh bread read at a particular time. This is
ideal when you would like fresh bread for when you get up in the morning or when you come home
from work. Use the "Timer" button to advance the time in 10minute increments. If necessary, use the
"Timer" button to decrease the time. When the delay timer is set where you want it, make sure to
press the "Start/Stop" button. The colon":" flashes and your bread will be ready when you planned.
The time which appears on the clock after it switches on automatically is the remaining baking time.
Therefore ensure you set the time for when you would like the bread ready. The maximum delay is
13 hours.
For Example
It is 8:30pm and you would like your bread to be ready the next morning at 7 o'clock. ie in 10hours
and 30 minutes. Press the " arrow pointing upwards" until 10:30 appears, as the time between "now"
(8:30pm) and the time the bread should be ready is 10 hours and 30minutes. If you work with the
delay timer option, do not use any work with the delay timer option, do not use any easily perishable
ingredients such as eggs, fresh milk, etc.
Keep Warm
Your bread is kept warm for 60 minutes after baking. If you would like to take the bread out during
this time, switch the program off with the Start/Stop Button.
Warning display
If the display shows "H:HH" after you have pressed Start. The temperature inside is still too high.
Press Stop: open the lid and let the machine cool down for 10to 20 minutes.
If the display shows "E:EE" after you have pressed Start, the temperature sensor is disconnected.
The sensor must be checked by an authorized service agent.
19