Tread Audio; Outils Et Matériel Nécessaires; Tread Audio Box Mounting Considerations; Mounting The Tread Audio Box Black Box Device - Garmin TREAD XL - BAJA RACE EDITION Manuel D'utilisation

Tread Audio

Garmin vous conseille vivement de faire installer l'appareil par un technicien expérimenté disposant
des connaissances appropriées en matière de circuits électriques. Le raccordement incorrect du câble
d'alimentation peut endommager le véhicule ou la batterie et entraîner des blessures corporelles.
You can use a connected Tread Audio system to control audio and LED lights from your Tread XL device.
Outils et matériel nécessaires
• Tournevis cruciforme
• Perceuse électrique
• Foret (la taille varie en fonction du matériel de montage et des vis utilisés)
• Pince pour sertir
• Dénude-fil
• Pistolet thermique
• Tournevis ou clés à six pans de 4 et 5 mm
REMARQUE : pour des installations sur mesure, des outils et du matériel supplémentaires peuvent être
nécessaires.

Tread Audio Box Mounting Considerations

In high ambient temperatures and after extended use, the device enclosure may reach temperatures deemed
dangerous to touch. Therefore, you must install the device in a location where it is not touched during operation.
The storage and operating temperature ranges for this device are listed in the product specifications. Extended
exposure to temperatures exceeding the specified temperature range, in storage or operating conditions,
may cause device failure. Device damage and related consequences caused by extended exposure to these
conditions are not covered by the warranty.
• You must mount the device in a location with adequate ventilation where it is not exposed to extreme
temperatures.
• You should mount the device so that the cables can be connected easily.
• To achieve IP67 water ingress protection and optimal heat sink cooling, you must mount the device on a
vertical surface with the connectors pointing downward.
• You can mount the device on a horizontal surface, but such positioning might not achieve IPX67 water
ingress protection.
• To avoid interference with a magnetic compass, you should install the device at least 203 mm (8 in.) away
from a compass.

Mounting the Tread Audio Box Black Box Device

Before you mount the device, you must select a mounting location, and determine what screws and other
mounting hardware are needed for the surface.
1 Place the black box device in the mounting location, and mark the location of the pilot holes.
2 Drill a pilot hole for one corner of the device.
3 Loosely fasten the device to the mounting surface with one corner, and examine the other three pilot-hole
marks.
4 Mark new pilot-hole locations if necessary, and remove the device from the mounting surface.
5 Drill the remaining pilot holes.
6 Secure the device to the mounting location.
Annexes
AVERTISSEMENT
ATTENTION
AVIS
65