Emerson RAH ECO CF915TM60BS00 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.9
NOTE: Only use the Hanger Ball supplied with this
Ceiling Fan.
Reinstall the Hanger Ball (Figure 9) on the Downrod as
follows:
Route the two 80-inch Motor Leads through the Hanger
Ball and slide the Hanger Ball over the Downrod.
Position the Pin through the two holes in the Downrod and
align the Hanger Ball so the Pin is captured in the Groove
in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and securely
tighten the Set Screw in the Hanger Ball.
NOTE: A loose Set Screw could create Fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure to
verify that the pin and set screw are properly installed
could result in the fan falling.
3.10
The fan comes with Black and White Leads that are
80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 10).
Cut off excess leads and strip back insulation 1/2-inch from
end of Leads.
Final Ceiling Fan installation will be completed after the
partially assembled fan is hung and wired.
(Continued)
PIN
HANGER
BALL
Figure 9
1/2-INCH
6 TO 9
INCHES
Figure 10
8
MOTOR LEADS
DOWNROD
CEILING
COVER
SET SCREW
BLACK WIRE
WHITE WIRE
HANGER BALL/
DOWNROD
ASSEMBLY
CEILING
COVER
U.L. Model No.: CF915