Error Messages; Error Messages On The Oel Display; Error Messages On The Display - Pioneer DVH-P7000 Mode D'emploi

Additional Information

Error messages

When problems occur with disc playback, an
error message appears on the display. Refer to
the table below to identify the problem, then
take the suggested corrective action. If the error
persists, contact your dealer or your nearest
PIONEER Service Center.

Error messages on the OEL display

Message Cause
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-14 Blank disc
ERROR-10, 11, Electrical or
12, 14, 17, 30, mechanical
A0
ERROR-44 All tracks are
skip tracks.

Error messages on the display

Message
ERROR-02
Action
THERMAL
Clean disc.
PROTECTION
IN MOTION
Replace disc.
Check the disc.
DIFFERENT
Turn the ignition
REGION DISC
ON and OFF, or
switch to a
different source,
then back to the
built-in player.
NON-
Replace disc.
PLAYABLE
DISC
Cause Action
The disc is dirty. Wipe the disc
clean. (See page
83.)
The disc is If the disc is
scratched. scratched,
replace it with
another. (See
page 83.)
The tempera- Wait until the
ture of this unit unit's tempera-
is outside of the ture returns to
normal operat- within normal
ing range. operating limits.
The disc does Replace the
not have the DVD with one
same region bearing the
number as this correct region
unit. number.
This type of disc Replace the
(CD-ROM etc.) disc with one
cannot be this unit can
played by this play. (See page
unit. 81.)
The disc is Check that the
loaded upside disc is loaded
down. correctly.
Section
12
En 89