Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
Locate Locking Clip
Location
Grasp the vehicle lap/shoulder
belts together tightly as close
to the vehicle latch plate as
possible. While holding the belts
tightly, unbuckle.
NOTE:
If the latch plate ends up just at the belt path opening
so you cannot grasp the vehicle belt at the latch plate, grasp
the vehicle belts on the opposite side of the child restraint, as
close to the latch plate as possible. Install the locking clip on
the latch plate end, as close as possible.
2.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking clip,
as close to the latch plate as
possible.
3.
Position Locking Clip
Position locking clip about 2.5
cm (1 in.) from vehicle belt's
buckle plate.
4.
Rebuckle Vehicle Belt
56
5.
Check Vehicle Belt
Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the
child restraint from side to
side, forward and back. The
child restraint should not
move more than 2.5 cm (1 in.) and the vehicle belt should
not loosen.
NOTE:
If it moves more than 2.5 cm (1 in.) or if the vehicle
belt loosens, try reinstalling the child restraint or try another
seating location.
Secure your child in the child restraint.
When installed rear-facing,
make sure the child restraint
is properly reclined according
to your child's weight.
When installed forward-
facing, make sure to tighten
the tether strap.
If you still have questions after installing the locking clip
please contact our Consumer Relations department.
Remove the locking clip when the vehicle seat belt is not
being used with a child restraint.
57
Publicité
Table des Matières
