Safety 1st Complete Air 65 LX Mode D'emploi page 26

G-3 Prepare UAS for
Forward-Facing Use
NOTE: Pull the UAS belt out of the rear-facing belt path if you
have used this child restraint rear-facing.
1.
Routing UAS
Insert the UAS connector
without the adjuster through the
forward-facing belt path.
2. Pull UAS Connector Across
to Opposite Side
Pull the UAS connector across
the back and out the other side
as shown. Do not twist the
UAS belt.
48
NOTE: Review your vehicle's owner manual for UAS belt use.
Adjuster
the child restraint flush against the vehicle seat back.
NOTE: Do not use the level to ground lines on the side of the
child restraint in the forward-facing position.
G-4 Install Forward-Facing
With UAS
Do not use the vehicle lap or lap/shoulder
belt when using the Universal Anchorage
System (UAS).
Check UAS belt before each use. Use only
if the belt can be tightened properly and
securely.
Do not fasten both UAS connectors on the
same UAS anchor bar in the vehicle.
Do not use any recline position except to
install the child restraint flush against the
vehicle seat back. Vehicle seat back must
be in the upright position.
Failure to follow these warnings can result
in serious injury or death.
1.
Place Child Restraint in
Vehicle Forward-Facing
in the Back Seat
Place child restraint flush
against the vehicle seat
back forward-facing.
Do not use any recline
positions except to make
49
continued on next page.