Accessories On Select Models; Reclining Child Restraint; Removing Harness System - Safety 1st Complete Air 65 LX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

C-5 Accessories on Select Models
Lumbar Support
To remove the lumbar support,
slide out from behind the
harness straps.
C-6 Reclining Child Restraint
This child restraint has 4
1
2
positions:
3
4
Rear-facing -
Fully recline the child restraint
so that the bottom level to
ground line is level with the
ground or for older children,
rotate the child restraint
between the top and bottom
level to ground lines on the
side of the shell.
Forward-Facing -
1
Upright or
When forward-facing, the semi-reclined position is to
NOTE:
be used only to install the child restraint flush against vehicle
seat back. Vehicle seat back must be in the upright position.
To recline, pull out on recline
handle and push top of child
restraint back.
For upright or semi-recline
position, pull out on recline
handle and pull top of child
restraint forward.
4
2
or
3
Semi-reclined.
22
C-7 Removing Harness System
Only remove the harness system to clean the seat pad.
1.
Unhook Harness Straps
from Splitter Plate
Fully loosen harness straps.
Starting in the back of the
child restraint, unhook
harness strap loops from
splitter plate.
2.
Remove Harness
1
Straps
2
From the front, pull harness
straps through the upper
harness guides (1).
4
3
Unthread harness straps
from the chest clip (2).
Unthread harness straps
from the buckle tongues
(3).
Holding one harness strap,
pull harness completely out
of lower harness guides (4).
3.
Locate Buckle Strap's
Metal Retainer
Fully recline the child
restraint. Reach under the
seat between base and shell.
23
continued on next page.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Complete air 65 se

Table des Matières