Safety 1st Complete Air 65 LX Mode D'emploi page 21

4.
Pull UAS Connector Across
to Opposite Side
Reach under pad and pull the
1
2
UAS connector across the shell
and out the rear-facing belt
path on opposite side. UAS belt
MUST be under pad and in
front of buckle strap.
Do not place belt over
child's legs.
NOTE: You must use the 1st
or 2nd buckle strap slots
when rear-facing.
5.
Replace Pad Over Corners
Make sure the UAS belt is not
twisted.
38
F-3 Install Rear-Facing with UAS
NOTE: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder
belt when using the Universal Anchorage
System (UAS).
Check UAS belt before each use. Use only
if the belt can be tightened properly and
securely.
Secure the tether hook
to the tether attachment
when used rear-facing.
Do not fasten both UAS connectors on the
same UAS anchor bar in the vehicle.
Fully recline the child restraint and rotate the
child restraint to the correct recline angle
that matches the weight of your child. Do not
use any other recline positions rear facing.
Do not rotate the child restraint beyond the
bottom or top level to ground lines.
Failure to follow these warnings can result
in serious injury or death.
1. Place Child Restraint in
Vehicle Rear-Facing in the
Back Seat
Child restraint MUST be in the
fully reclined position when
rear-facing. To recline, see
section C-6.
39
continued on next page.