Allmatic B.RO X40 DISPLAY Mode D'emploi page 33

• Output active, LED on.
• Output active and timed, slow blinking.
• Output delayed waiting for activation, fast blinking.
The receiver will enter the standby mode after 2 minutes of inactivity. The display shows
For exit the mode press briefly a key of the receiver.
7
DISPLAY AND STATUS OF THE CONTROL UNITS
7.1 - NORMAL FUNCTIONING

Standby.

Outputs not activated.
   
Output 1 active.
  
Output 2 active.
  
Output 3 active.
 
Output 4 active.

Countdown associated to the output (in the example relay 4).
 
Displayed during the learning by default.
 
Displayed during the sequential learning.
 
Displayed during the advanced learning.

Displayed when a key of a new transmitter has been learned.

Displayed when a key of a new transmitter has been learned during the advanced learning.

Appears when learned one key of a transmitter already learned.

Indicates the position in the default transmitter memory.

Indicates the position in an already-learned transmitter memory.

Indicates a free position in the memory for the learning of a new transmitter.
 
Appears when the default parameters are restored.

Appears during the cancelation process of all the transmitters.
 
Appears when all the transmitters are canceled.

Appears when a single transmitter is canceled.

Appears during the reset of the transmitters, if memory is not present.
Appears when the control unit is waiting for a signal from a transmitter during the remote control

assessment mode.
7.2 - ERROR REPORTING

Memory not found, not assembled, not electrically functional.

Wrong memory size.

Memory full.

Incorrect coding type or not compatible with the detected memory, or wrong signature.

Wrong identifier code (IdCode).

Supply voltage lower than 8.4 V - possible malfunction of the relays.
6-1620020 rev.3
ITA
05/12/2022
ENG FRA ESP

and the LED OUT are disabled.
13/20