Allmatic B.RO X40 DISPLAY Mode D'emploi page 27

4
MENU
To enter inside the base menu, press the MENU button for at least 1 second.
After the MENU button is pressed, the password is requested, if it has been set (see paragraph 4.1.1).
Use UP (+) and DOWN (-) buttons to move inside the items of the menu, while with the long pressure of the MENU button it is
possible to:
• enter the following group of parameters;
• enter the following step of the running process, or finish the procedure if it is in the last step (the changes are saved;
• enter the change mode, in the case of parameters that can be changed;
• save the parameter just modified.
During the change of the selected parameter, the value starts blinking. It is possible to change its value with the use of the UP[+] and
DOWN[-] buttons. Instead, with a short pressure of the MENU button it is possible to:
• cancel the change of the parameter in progress;
• go to the previous group of parameters;
• go to the previous step of the procedure in progress.
To quit the menu, press briefly the MENU button until the display shows
MENU
PARAMETERS OF THE RECEIVER
Sub-menu of the receiver where it is possible to:
- set the password (PWD);
- enable/disable the learning of the transmitters through the buttons in the receiver (HEYB);
PARAM
- enable/disable the hidden key of the transmitters (HIde);
- set the function associated to a single wired input (Input);
- set the time and the delay of the outputs that are used with Timed function or Timed+Delay function (rtime);
- reset the receiver to default settings (def).
PERSONALIZATION OF THE TRANSMITTERS
MODIF
Sub-menu where it is possible to change all the parameters of a remote control that is located in the memory.
RESET OF THE TRANSMITTERS
It erases from the memory all the memorized transmitters. During this process it is possible to select the type of
TRF coding that you want to set to the receiver:
- biroL: Rolling Code Allmatic;
- sawn: Custom.
CHECKING MODE OF THE REMOTE CONTROL
It checks if the transmitter is memorized and shows:
SEE - the location in the memory;
- the index of the pressed key;
- the outputs that are associated to the key.
4.1 Param - SUB-MENU FOR PARAMETERS
MENU
PASSWORD
Pwd
Value for the protection of the menu.
LEARNINGS
HEYb It is possible to enable or disable the learnings of the transmitters
through buttons in the receiver.
HIDDEN KEY (only with biroL coding)
HIde
It is possible to enable or disable the hidden key of transmitters.
PARAMETERS FOR THE WIRED INPUT
With the selection of the wired input (I01, I02, I03 o I04) you can
associate to it the output function (FUnCT):
InPUT
- f00: Dead Man;
- f01: Step by Step;
- f02: Timed;
- f03: Timed+Delay.
6-1620020 rev.3
DESCRIPTION
ITA
05/12/2022

, or wait 1 minute of inactivity.
DESCRIPTION
ENG FRA ESP
SELECTABLE
VALUES DEFAULT
min-max
0(OFF)-9999 OFF
ON-OFF ON
ON-OFF ON
0-3 0
UNIT
7/20