Electrical Connections - Allmatic B.RO X40 DISPLAY Mode D'emploi

REMARKS
Please read this instruction manual very carefully before installing and programming your control unit.
After the installation keep this instruction in a safe place for any further consultation.
• The device must not be used by people (children included), whose physical, sensory and mental capacities are reduced, or without
experience or knowledge, unless they could benefit through the intermediation of a person responsible for their safety, of a
surveillance or of instructions related to the use of the device.
• Children must be kept under surveillance to make sure that they do not play with the device.
• If the power supply's cable is damaged, it must be replaced by the manufacturer or by his assistance service or in any case by a
person with similar status in order to prevent any risk.
• This instruction manual is only for qualified technicians, who specialize in installations and automations.
• The contents of this instruction manual do not concern the final user.
• Every programming and/or every maintenance service should be done only by qualified technicians.
• The installer must provide the installation of a device (es. magnetothermical switch) that ensures the omnipolar sectioning of the
equipment from the power supply.
1
DESCRIPTION
B.RO X40 Display is a 4-channels Rolling Code receiver compatible with all Allmatic Rolling Code remotes. This device has an easy
and intuitive functioning thanks to the display interface and 3 buttons. 4 relay outputs are available with dry contact normally open
(N.O.) and/or closed (N.C.). Outputs can work with 4 different modes: dead man, step by step, timed and timed with delay. Each
output can be controlled by a dedicated wired input or by a single key of a memorized transmitter. The output function is directly
associated to the input command and no to the relay.
The learning of a key of a transmitter can be realized with 3 procedures: default learning (customizable), sequential and advanced.
Power supply 12-24 Vdc/Vac with automatic selection of the voltage.
2

ELECTRICAL CONNECTIONS

CONNECTIONS
1-5:
wired input (N.O. contact) for relay 1.
2-5: wired input (N.O. contact) for relay 2.
3-5: wired input (N.O. contact) for relay 3.
4-5: wired input (N.O. contact) for relay 4.
6-7: power supply.
8-9:
relay output 1 (N.O. contact).
9-10: relay output 1 (N.C. contact).
11-12: relay output 2 (N.O. contact).
2/20
DISPLAY
20 21
UP DOWN
MENU
+ -
INPUTS LED
1 2 3 4 5 6 7 8
ITA ENG
RADIO MODULE
MEMORY
OUTPUTS LED
OUT1 OUT2 OUT3
9 10 11 12 13 14 15 16 17 18 19
12-13: relay output 2 (N.C. contact).
14-15: relay output 3 (N.O. contact).
15-16: relay output 3 (N.C. contact).
17-18: relay output 4 (N.O. contact).
18-19: relay output 4 (N.C. contact).
20:
antenna braiding.
21: antenna.
FRA ESP
OUT4
6-1620020 rev.3 05/12/2022