Allmatic B.RO X40 DISPLAY Mode D'emploi page 23

3
LEARNING OF A TRANSMITTER
The device has available 3 modality for the learning of a transmitter:
• Default learning - press briefly the UP (+) button for the activation.
• Sequential learning - press briefly the DOWN (-) button for the activation.
• Advanced learning - press briefly the MENU button for the activation.
ATTENTION: outputs are disabled during the learning.
3.1 - DEFAULT LEARNING
The default learning memorizes all keys of a remote control with a single press of a key.
The memorized transmitter will have the same settings of the default transmitter. The default transmitter is stored in the memory
and his parameters could be personalized inside the modif menu with the selection of the pdef position (see paragraph 4.2).
If the remote is already memorized, a new learning restores the transmitter to the default values.
The receiver exits from the learning phase after 10 seconds of inactivity or with the press of the UP (+) button.
NOTE.
The default transmitter leaves the factory with the following settings:
- Key 1 (b01) activates OUT1 output (CH01) with dead man function (F00).
- Key 2 (b02) activates OUT2 output (CH02) with dead man function (F00).
- Key 3 (b03) activates OUT3 output (CH03) with dead man function (F00).
- Key 4 (b04) activates OUT4 output (CH04) with dead man function (F00).
- Keys from 5 to 16 (b05...b16) are with dead man function (F00), but they are not associated to any outputs.
ATTENTION: with the default learning, B.RO OVER and TECH3 PLUS transmitters are associated to outputs in this way:
- Upper key (b01) activates OUT1 output (CH01) with dead man function (F00).
- Central key (b03) activates OUT3 output (CH03) with dead man function (F00).
- Lower key (b02) activates OUT2 output (CH02) with dead man function (F00).
6-1620020 rev.3
Make sure that the receiver is out from any menu.
Press briefly the UP (+) button.
Press a key of the transmitter.
The display shows the position in the memory, for example:
Otherwise, if the remote is already memorized, a new learning restores the
transmitter to the default values and the display shows:
The receiver waits for a new transmitter.
To quit, press briefly the UP (+) button or wait 10s of inactivity.
ITA
05/12/2022
The display shows:

The display shows:
 

The display shows:


The display shows:
 
ENG FRA ESP
3/20