Allmatic B.RO X40 DISPLAY Mode D'emploi page 30

MENU
REMOVAL OF THE TRANSMITTER
deL
It allows the removal of the single transmitter.
ENABLING OF THE TRANSMITTER
enab
It allows to enable or disable the transmitter.
MOVING OF THE TRANSMITTER
move It allows to move the location where the transmitter has been
registered in the memory.
BUTTONS PERSONALISATION
By selecting the button (b01, b02, ..., b15, b16) it is possible:
• to associate the output function (FUnCT):
- F00: Dead Man;
btn
- F01: Step by Step;
- F02: Timed;
- F03: Timed+delay.
• to associate output channels (CH01, CH02, CH03, CH04).
4.2.1 deL - REMOVAL OF THE TRANSMITTER
By accessing the item deL it is possible to delete the single transmitter from the receiver.
In order to proceed with the removal, move to the item deL and then confirm by a long pressure of the MENU button. Keep pressed
until the display shows the value 0, then release the button. Hold again the MENU button: a countdown starts d20, d19, ..., d1, d0.
Once the countdown ends, the reset has successfully been performed, and the display shows
4.2.2 enAb - ENABLING OF THE TRANSMITTER
It allows to enable or disable the single transmitter. This function serves to disable the transmitter during a period of time, without
removing it from the memory and thus maintaining the configured characteristics.
4.2.3 Move - MOVING OF THE TRANSMITTER
It allows to move the position of the transmitter in the receiver's memory.
In order to proceed with the change, move to the item Move, then confirm with a long pressure of the MENU button. Keep pressed
until the display shows the first free position (e.g. p000), then release the button. The positions of the memory occupied by a
transmitter are indicated by the presence of a point between the digits (for example P0.0.1).
Use the UP (+) and DOWN (-) buttons to select the desired position and confirm by a long pressure of the MENU button. Keep
pressed until the display shows the value Moved, then release the button.
4.2.4 btn - BUTTONS PERSONALISATION
It allows to personalize the transmitter's single button. It is possible to associate the function and the output channels (even more
than 1) to each transmitter's button.
Please follow the procedure below to proceed with the changes:
Select the button to modify with the UP (+) and DOWN (-) buttons of the receiver.
10/20
DESCRIPTION
Press and hold the MENU button until the display shows:
If the key was already saved, the display can show the function previously

Select the desired function with the UP (+) and DOWN (-) buttons.
ITA
The display shows:
 
-

assigned:
 
ENG FRA ESP
SELECTABLE
VALUES DEFAULT
min-max
ON-OFF ON
000-999
 .
6-1620020 rev.3
UNIT
05/12/2022