Allmatic B.RO X40 DISPLAY Mode D'emploi page 24

3.2 - SEQUENTIAL LEARNING
The sequential learning memorizes the single key of a transmitter and it associates the key on the desired output.
To the stored key is assigned the DEAD MAN function.
The receiver exits from the learning phase after 10 seconds of inactivity or with the multiple press of the DOWN (-) button.
This learning is activated also with the press of the hidden key of a stored remote control. For the selection of the desired output,
press more times the hidden key.
OUT1, OUT2, OUT3 and OUT4 LEDS indicate the involved channel during the
For the selection of the channel press and release the DOWN (-) button until the
To change the selected channel, press and release the DOWN (-) button until the
To quit, press and release DOWN (-) button until you switch off of all LEDs of the
4/20
Make sure that the receiver is out from any menu.
The display shows:
Press briefly the DOWN (-) button.
The display shows:
lighting of the corresponding LED.
Press a key of the transmitter.
The display shows the position in the memory, for example:
The display shows:
Otherwise, if the remote is already memorized, the display shows:
The receiver waits for a new key to be memorized.
The display shows:
lighting of the corresponding LED.
outputs or wait 10s of inactivity.
ITA

 
learning.



 
ENG FRA ESP
6-1620020 rev.3 05/12/2022