WMF KÜCHENminis Vario Mode D'emploi page 12

▪ Always completely empty the kettle. Do not let any residual water remain in the device for a long
period of time.
▪ The mains plug is to be pulled:
⋅
if malfunctions occur during use,
⋅
before cleaning and care,
⋅
after use.
▪ No liability is accepted for any damages resulting from misuse, incorrect operation or improper
repairs.
Claims under warranty are likewise excluded in such cases.
▪ Packaging material, such as plastic film bags, do not belong in the hands of children.
Operating the appliance for the first time and general information
The kettle is made from stainless steel and original Schott DURAN® glass. It is heat resistant, stable,
neutral tasting and easy to clean.
Thoroughly clean the inside of the kettle prior to the first use. (see the chapter entitled "Cleaning and
care").
A strainer insert in the pour spout ensures that larger limescale particles are kept back when pouring.
The unnecessary length of the connecting cable can be wound at the bottom of the base part.
Connect the mains plug to an earthed socket.
Add the desired amount of water (min. 200 ml, max. 1,000 ml).
Note: If you use too little water, the dry-run protection (overheating protection)
automatically switches the heating element off. If there is too much water then hot water may boil
over, which can cause serious injury or burns.
The lid (2) must audibly lock into place; only in this way does the automatic boil stop work reliably.
Place the kettle on the base in any position.
Do not use the water from the first boiling process for food preparation.
The following functions are available:
Boiling water
1. Open the lid (2) by pressing the button on the handle (5) and remove the tea strainer (4).
2. Fill the kettle with the desired amount of water (min. 200 ml, max. 1,000 ml).
3. Close the lid (2) until it locks into place to enable the automatic boil stop to function reliably.
4. Put the kettle back onto the base (8) in any position.
5. Press the Start/Stop button
70°, 80°, 90° or 100°C). If you want to change this, press the appropriate button for your desired
temperature (9). Alternatively, you can also switch the kettle on by directly pressing the respective
button for your desired temperature.
Note: If no key is pressed for 10 seconds, the kettle automatically switches itself off. The indicator
lights go out and the power consumption is then less than 0.5 watts.
6. Press the Start/Stop button
the kettle lights up. You can interrupt the brewing process at any time by pressing the Start/Stop
button again.
7. As soon as the desired temperature has been reached, the appliance beeps (several times at certain
intervals) and switches itself off automatically.
The button lighting and the LED ring (7) goes out.
Making tea with loose leaves
Follow steps 1 to 7 described above (see the chapter entitled "Boiling water") to heat the water up to
the desired temperature.
Fill the tea strainer (4) and follow the instructions on the packaging when portioning out the tea. As a
12
. The most recently selected temperature button lights up (60°,
to start heating. The Start/Stop button and the LED ring (7) inside