Configure Sunny Data Control - SMA USB-SERVICE-INTERFACE Instructions D'installation

SMA Solar Technology AG
5.6 Configure Sunny Data Control
Requirement:
☐ The COM port of the USB service interface is known (see Section 5.4 "Locate the COM port of
the USB Service Interface", page 51).
1. Start Sunny Data Control.
2. Create new plant, for example named USB Service Interface (see the "Sunny Data Control"
operating instructions).
3. Select Settings > Communication.
4. In the "Connection via" drop down list, select COM port of the USB service interface.
5. Select [Settings].
6. In the "Media type" drop down list, select RS232.
7. In the "Bits per second" drop down list, select 1200.
Installation Guide
5 Initial Start-up
USBPBS-IXX103813 53