Lavorwash THERMIC 13 H Mode D'emploi page 14

Whenever you need to stop the machine, it is
necessary to use the safety lock
gun, in order to avoid fortuitous openings (fig. 1).
fig. 1
S
II. DETERGENT SUCTION
fig. 2A
(fig. 2A). Plunge suction hose with filter into
detergent tank (fig. 2B).
automatic when the adjusting head of the lance is
rotate for low pressure operation (anti-clockwise).
CAUTION: make use only of liquid detergent,
do not absolutely use acid or too much alkaline
products. We suggest you to make use of our
products, which have been studied for the use with
washer machines.
III. USE OF THE LANCE
The adjusting head allow you to select water
(fig. 3).
jet at low and high pressure. The pressure selection is
14
, placed on the
S
fig. 2B
The detergent suction is
fig. 3
carried out by rotating the adjusting head. To increa-
se the pressure, rotate the adjusting head clockwise,
to reduce the pressure rotate it anti-clockwise.
IV. APPLIANCES PROVIDED WITH THERMAL
VALVE
This device enables the machine's by-pass
operation through automatic water discharge
whenever it reaches a temperature of nearly 60°C
and cooling working components.
CAUTION: appliances that are not provided
with this disposal must not operate for more than
2 minutes with released gun. Recycled water raises
its temperature remarkably causing great damages
to the pump.
OPERATING INSTRUCTIONS
CAUTION! Do not run the engine with a high
or low oil level as this can cause engine damage. If
you have further questions regarding the engine,
please refer to the engine's operating manual
included with the unit.
CAUTION! The engine is not provide with oil.
It is necessary to fil the carter before starting the
engine.
CAUTION! Before starting the pump, check the
oil level in the pump.
CAUTION! If it is the first time that you use the
machine or if you do not operate the machine for
a long period, it is necessary to connect, for some
minutes, the suction hose, in order to let possible
impurities go out, so that the nozzle gun will not
become clogged.
CAUTION! Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
I. STARTING UP
WATER SUPPLY
Water supply connection - Additional safety
information
WARNING: (symbol) machine not suitable
for connection to the potable water mains.
Caution - Danger!
Only clean or filtered water should be used
for intake. The water intake should be at least