Pleasant Hearth OFG828T Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
6. Side Panel Installation:
Attach three side panels (H) to the posts (F and G)
with twelve M6 X 12 bolts (AA). Tighten with
screwdriver (FF). After installation, the base assembly
will look like figure 6.
Hardware Used
AA
M6 X 12 bolts
FF
Phillips screwdriver
7. Table Installation:
Make sure the control knob (P) on the table (D)
faces the door (L). Line up the holes on the posts
(F and G) with the corresponding screw holes on
the table (D).
Insert four M6x12mm bolts (AA) through the holes
on the four posts (F and G) into the screw holes on
the table (D). Tighten with the screwdriver (FF).
After assembly, the assembled unit will look like
figure 7.
Hardware Used
AA
M6 X 12 bolts
FF
Phillips screwdriver
6
G
X 12
7
P
L
F
AA
X 4
11
F
G
AA
G
AA
D
AA