Pleasant Hearth OFG828T Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS
4. Hang the chain (I) from the posts (G) as illustrated in
figure 4 so that it connects from corner to corner.
5. Door installation:
Ensure the tank hole on the bottom plate (K) is in
front as pictured. Insert the spindle at bottom of the
door (L) into the corresponding hole on the bottom
plate (K). Hold the door (L) in place and put the door
bracket (E) on top. Attach the door bracket (E) to the
front right post (F) and front left post (G) with two
M6X12 bolts (AA). Make sure to adjust the gap
between the door (L) and door bracket (E) to make it
even when tightening the bolts. Do not put door
bracket (E) too close to the door (L) to ensure that it
can open and close easily. Tighten with phillips
screwdriver (FF).
Hardware Used
AA
M6 X 12 bolts
FF
Phillips screwdriver
4
G
5
X 2
10
I
I
G
L
E
G
E
L
G
G
AA
AA
F
K