Signature Kitchen Suite SKSFD4826P Manuel D'installation page 21

en-us_main.book.book Page 21 Monday, January 30, 2023 4:04 PM
2
Use the mark on the gauge tool to adjust the depth of the appliance in the enclosure.
Place the gauge tool against the closed door of the appliance at the side of the enclosure. The marked
notch on the gauge tool should align with the front edge of the enclosure.
Height Adjustment
The front and rear leveling legs can both be adjusted from the front.
Front adjustment
a
Rear adjustment
b
Leveling
Once the appliance is aligned properly in the enclosure, level it using the front and rear leveling legs.
NOTE
• If you level the appliance properly, you should need fewer adjustments to the doors and drawers.
• Use a spirit level rather than surrounding cabinets to judge whether the product is level.
1
Use the wrench included in the product and an M8 wrench to extend the front and rear leveling legs
until they are in firm contact with the floor.
INSTALLATION 21