Witter MZ49U Notice De Montage

Fitting
Instructions
MATERIALS
A 1 Cross bar
B 4 M12 x 1.75 x 35mm Bolts and Nyloc Nuts
C 4 M10 x 1. 5 x 40mm Bolts , Lock Washers and Large Flat Washers (30mm)
D 1 Sidearm
E 1 Sidearm
S 1 Safety Chain Plate (stainless)
EP 1 Flip up Electrical Plate (Z99)
ZEQ5 1 Angle Plate
For use with either
MZ49QF Detachable Flange neck option – ZQF3008. Note: This towbar must be used with either a Witter Towball (part
number Z11) or Class A50-1 or A50-X towball, which dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal
to that of the towbar.
MZ49Q Detachable neck option – ZQ3008. Please refer to ZQ fitting instructions for installation
FITTING
1. Remove bumper. Release wheel arch liners from bumper tips and remove screw from top corner on inside edge.
Remove 2 tip screws and 3 push clips along bottom edge and slide panel in centre of bumper forward (this is not
refitted). Remove plastic trim along bottom edge of boot opening (2 clips each side and pull upwards), pull inner boot
trim in to reveal 3 x hex nuts securing light clusters, disconnect electrics and pull cluster rearwards. Hatch models only
have 2 screws under colour coded covers on bottom edge of boot opening. Release clips & screws under light clusters
and slide bumper rearward.
Remove crash beam and discard.
2.
Insert Sidearms as per sketch and secure (forward fixing on right side is forward of fuel lines and access is better if
3.
wheel is removed.
Loosely attach Crossbar (A) using bolts (B), see sketch below for correct orientation.
4.
Fully tighten all bolts and refit bumper etc.
5.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
#NAME?
W0001MZ49U-FIT$010910220000
TOWBAR
MZ49U
For MAZDA 3
Saloon and Hatch
2009 –