Witter MZ53U Notice De Montage

MATERIALS
A 1 Cross Bar
B 1 Side Arm
C 1 Side Arm
D 2 M12 x 35mm x 1.25mm Bolts, Flat Washers, and Lock Washers.
E 2 M12 x 35mm x 1.25mm Bolts, and Lock Washers
F 4 M12 x 35mm x 1.75mm Bolts, and Serrated Flange Nuts
ZE 1 Retractable Electrical Plate.
ZN 1 Neck Kit
FITTING
Locate each mounting point on the outside face of each chassis rail and remove the sealing tape.
1.
Loosely assemble Side Arms (B & C) to each chassis rail using fasteners (D & E)
2.
Cut the bumper as shown.
3.
Assemble Cross-Bar (A) to Side Arms (B & C) using fasteners (F)
4.
Assemble the chosen Neck Kit (ZN) and Retractable Electrical Plate (ZE) to Cross Bar (A) using separate instructions..
5.
Note: The exhaust heat shield may need bending away from the Tow Bar to avoid vibration noises.
6.
7. Fully Tighten all fasteners.
Recommended torque settings:
Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200 Nm
M12 – 120Nm, M10 – 70Nm M8- 35Nm
Grade 10.9:
Fitting
Instructions
W0001MZ53U-FIT$011302220000cÄ
W0001MZ53U-FIT$011302220000
For Mazda 6 Saloon and Estate 2013-
TOWBAR
MZ53U