Witter MZ54U Instructions De Montage

MATERIALS
A 1 Main Crossbar.
B 1 L/H Sidearm.
C 1 R/H Sidearm.
D 1 R/H Exhaust Support.
E 1 L/H Exhaust Support.
F 4 M12 x 40 1.25 fine pitch bolts, lock washers 25 O/D washers, and 8 x 30 O/D washers 2off per bolt (as
spacers)
G 4 M12 x 35 x 1.75 Bolts, 2 x 25 O/D washers and Nyloc nuts.
H 2 M6 x 20 Bolts, 2 x washers and Nyloc nuts.
J 2 M10 x 60 x 1.5 bolts, washers and Nyloc nuts. (to support exhaust rubbers, clamp with bolt and washer)
X 8 Existing nuts.
ZE 1 Electrical plate.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball, which
dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
FITTING
1. Remove bumper, rear light clusters and demount exhaust rubbers on both sides.
2. Remove crash beam and retain fixings ( retain crash beam to hand to customer)
Mount silencer supports "D" & "E" using retained fixings "X" from crash beam.
3.
Using fixings "F" with 2 off 30mm washers per bolt as spacers against chassis, loosely attach side arms "B" & "C".
4.
Using fixings "G" Loosely mount main crossbar to the side arms "B" & "C".
5.
6. Tighten all fixings to correct Torque values, Attach chosen neck option, cut bumper to suit chosen neck. Note: smaller
cut needed for neck non retractable electrical plate options . Replace bumper etc.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
Fitting
Instruction
s
W 0 0 0 1 M Z 5 4 U - F IT $ 0 1 0 8 0 2 2 2 0 0 0 0
For Mazda 3 5D HB 2013 -
#NAME?
TOWBAR
MZ54U