Matrix T3xe Mode D'emploi page 5

NOTE
(T3XM ONLY)
1. This equipment is designed as an auxiliary device to
assist medical personnel to improve their patients'
health.
2. This equipment is designed for uses in cardiovascular,
physical rehabilitations and recoveries under medical
personnel's instructions and monitoring.
3. The waterproof level of this equipment is IPXO.
4. This equipment has no sterilization.
5. This equipment is not suitable for uses in oxygen rich
environments.
6. This equipment is designed for continous operation.
7. This equipment complies with WEEE directives for
disposal and recycling.
8. Ambient temperature for operating this equipment is
5°C - 40°C (with NO air-flow), nominal 25°C.
9. Relative Humidity for operating this equipment is 10% -
90% (non-condensing), nominal 40% (non-condensing).
10. Ambient temperature for shipping and storage this
equipment is from -20°C to 70°C (with NO air-flow).
11. WARNING: Do not modify this equipment without
authorization of the manufacturer.
12. Paramedics and medics are the users. Users are
trained to operate the device, T3xm, according to the
instructions.
13. The user sets workout program and directs Patient to
exercise.
WARNING!
• Connect this exercise product to a properly grounded outlet only.
• Never operate product with a damaged cord or plug even if it is working properly. Never operate any product if it
appears damaged, or has been immersed in water. Contact Customer Tech Support for replacement or repair.
Failure to follow these specifications can cause damage to your product and can void the warranty:
• All video and power outlets must be functional the day of delivery / assembly of the product. The
client is responsible for any additional installation charges associated with return visits.
• Electrical supply may fluctuate in your area. To ensure stable performance of the product, use the proper gauge wire.
ASSEMBLY
UNPACKING
Unpack the equipment where you will be using it. Place the carton
on a level flat surface. It is recommended that you place a protective
covering on your floor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this off. If you have difficulty,
a light application of lithium grease is recommended.
WARNING!
There are several areas during the assembly process that
special attention must be paid. It is very important to follow
the assembly instructions correctly and to make sure all parts
are firmly tightened. If the assembly instructions are not
followed correctly, the equipment could have parts that are not
tightened and will seem loose and may cause irritating noises.
To prevent damage to the equipment, the assembly instructions
must be reviewed and corrective actions should be taken.
NEED HELP?
If you have questions or if there are any missing
parts, contact Customer Tech Support. Contact
information is located on the information card.
TOOLS REQUIRED:
F 8mm T-Wrench
F 5mm Allen Wrench
F 6mm Allen Wrench
F Phillips Screwdriver
PARTS INCLUDED:
F 1 Base Frame
F 2 Console Masts
F 2 Console Mast Brackets
F 1 Console Assembly
F 2 Handlebar Covers
F 1 Power Cord
F 1 Hardware Kit
Console sold separately
DANGER!
Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or serviceman if you are
in doubt as to whether the product is
properly grounded. Do not modify the
plug provided with the product. If it will
not fit the outlet, have a proper outlet
installed by a qualified electrician.
5