Spectrum Mode; Factory Reset - Maxspect Ethereal Mode D'emploi

Operating Instructions
Switching between Spectrum and Photo-Period Mode:
The Ethereal LED Lighting System has two modes of operations: Spectrum and Photo-Period
English
Mode. User can switch between the two modes with the control dial on the fixture.
Press and hold the control dial for 2 seconds (but less than 5 seconds) to switch to another
mode.

Spectrum Mode:

Under Spectrum Mode, the fixture will simply leave the intensity of the 5 LED channels at the
last saved setting.
To adjust the intensity, press the control dial once to enter Setup Mode (the RGB Mood Light
will start to blink). Rotate the control dial to adjust the intensity. Press the control dial again to
switch to the next channel, until all 5 channels have been set. Press the control dial one more
time to exit Setup Mode (the RGB Mood Light will stop blinking).
Photo-Period Mode:
Under Photo-Period Mode, the fixture will run the last saved Photo-Period profile.
Note: For instructions on setting up the Photo-Period Mode, please refer to the embedded user
manual within the Android/iOS app.

Factory Reset

To factory reset the fixture, first enter the Demo Mode. Turn off the fixture then press and hold
the control dial before turning the fixture back on. The fixture will now be put in Demo Mode,
where all LED channels will be lit at 1%, the fan will be engaged and the RGB Mood Light will
systematically blink to indicate the coded firmware version.
While in the Demo Mode, press and hold the control dial for 5 seconds, all settings
will then be reset, including the ICV6 network connection setting.
8