Publicité
Les langues disponibles
Les langues disponibles
CARE & MAINTENANCE
SUGGESTED CLEANERS:
Cerama Bryte®
EN
Carbona®
Hope's® Cooktop Cleaning Cream
Affresh® Cooktop Cleaner
Weiman® Cooktop Cleaning Cream
Easy-Off® 3-in-1 Glass Top Cleaner Spray
EXTERIOR SURFACES
EXTERIOR SURFACES
Do not allow food stains or salt to remain in contact with stainless steel surfaces too long. All
stainless steel exterior surfaces may be cleaned with warm soapy water, or any number of commercial
stainless steel cleaners. Check to make sure the cleaners do not contain chlorine or chlorine
compounds as these are corrosive to stainless steel. Rinse thoroughly.
SUGGESTED CLEANERS:
Hot water & mild detergent
Fantastik
ALWAYS clean stainless steel in the direction of the grain with light pressure.
For painted surfaces, use a mild household liquid detergent solution to remove dust and other
deposits. Never use any solvent-based cleaners, stainless steel cleaners, heavy degreasers, oven
cleaners, etc. on the painted surfaces. They can permanently damage the paint. Rinse off with clean
fresh water and dry with a clean cloth.
Wait until the appliance is completely cool before using any aerosol-type cleaners. Many of these
cleaners use flammable propellants which could ignite in the presence of heat.
REPLACING THE OVEN LIGHT BULB
REPLACING THE OVEN LIGHT BULB
ELECTRICAL SHOCK HAZARD - Make sure the power has been shut off to the range. The light
socket is energized when the door is open. Failure to shut off the power when replacing a light bulb
could result in electric shock or burns.
Make sure the glass lens is cool to the touch. Use care when handling the lens, it is fragile and can
break if dropped.
Use only 20 watt, 12 Volt, halogen "Bi-Pin" bulbs suitable for appliance oven use. This type of bulb
may be available at hardware stores and home centers, or specialty lighting stores. Call Hestan
Customer Care for more information.
1. MAKE SURE POWER IS OFF! Open the oven and remove the oven racks and ladder racks if they
are in the way.
2. Place a thick towel or cloth on the oven floor below the lamp to catch the glass lens should it fall.
3. Use a small flat-blade screwdriver to carefully pry off the glass lens and set aside. Reach into the
lamp housing and pull out the old light bulb as shown in the image below.
4. Before installation, it is very important to clean the new bulb carefully with a clean, soft cloth, or
tissue paper. Grease, fingerprints, or oils in your skin can leave a residue on the glass surface of
the bulb which will create a hot-spot. The bulb will eventually crack at this hot-spot.
50
©2021 Hestan Commercial Corporation
®
(CONTINUED)
Publicité
