Application Of Burner To Boiler - baltur TBG 45PN Mode D'emploi

APPLICATION OF BURNER TO BOILER

- Adjust the position of connector flange 5 by loosening the
screws 6 so that the combustion head penetrates the advised
amount into the combustion chamber as recommended by the
genertor's manufacturer.
Following the drawing, connect the tube on the attachment on
the flange and fix with the screw
- Position the seal insulation 3 on the tube unit inserting cord 2
between flange and seal.
- Fasten the Combustion Head unit 4 to the boiler 1 by means
of the stud bolts, washers and the nuts provided 7.
Note: isolate completely, with suitalbe materia the space
between the burner tube and the hole on the refractory ma-
terial inside the boiler's shutter.
ASSEMBLING THE GAS TRAIN
There are different ways of assembling the valve train, 8, 8a and 9
as shown in the drawing. The burner is supplied with the gas train
connection facing downward. If you wish to invert the direction of
train entrance to allow the valve set to be assembled in configuration
9, follow the procedure described in the section entitled: "Preparation
for connection with train turned upward".
Choose the most rational position for the set-up of the boiler room
and the position in which the gas pipe arrives.
Tube fixing screw
Combustion chamber
pressure detection point
Combustion chamber
pressure transmission tube
7 / 8
000608367_200806
Combustion chamber pressure
detection stiff tube
Cut in line with diffuser
E
N
G
L
I
S
H