Bosch RIDE+ Performance Line Manuel Du Propriétaire page 126

Code Cause
510 Internal sensor error
511 Internal error in the drive unit
530 Battery pack error
531 Configuration error
540 Temperature error
550
An improper load was detected.
580 Software version error
591 Authentication error
592 Incompatible component
593 Configuration error
595, Communication error
596
602 Internal battery pack error while charging
602 Internal battery pack error
603 Internal battery pack error
605 Battery pack temperature error
605 Battery pack temperature error while charging
Bosch eBike Systems
Corrective Action
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Switch off the eBike, remove the eBike battery pack and
reinsert the eBike battery pack. Restart the system. If the
problem persists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
The eBike is outside of the permissible temperature range.
Switch off the eBike system and allow the drive unit to ei-
ther cool down or heat up to the permissible temperature.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Remove the load. Restart the system. If the problem per-
sists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Switch off the eBike system. Remove the battery pack and
reinsert it. Restart the system. If the problem persists,
contact your Bosch eBike dealer.
Insert a compatible display. If the problem persists, con-
tact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Check the wiring to the transmission and restart the sys-
tem. If the problem persists, contact your Bosch eBike
dealer.
Unplug the charger from the battery pack. Restart the
eBike system. Plug the charger into the battery pack. If the
problem persists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
The eBike is outside of the permissible temperature range.
Switch off the eBike system and allow the drive unit to ei-
ther cool down or heat up to the permissible temperature.
Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Unplug the charger from the battery pack. Allow the bat-
tery pack to cool. If the problem persists, contact your
Bosch eBike dealer.
125
English–10
1 270 U20 XBP | (21.4.16)