Installaton Of The Kit For Powder And Granular Treatments - Efco AT900 Manuel D'utilisation Et D'entretien

I
NSTALLATON OF THE KIT FOR POWDER AND
Before to start, read with attention as follows:
Warning: All operations described in this instruction must be carried
out with
the liquid tank before to disassemble it from the machine,
according
"Instructions and maintenance manual" supplied with the machine.
Warning: in case your mist blower is endowed with a booster pump
(code 56062001) or a booster and filling pump (code 56062002), the
pump must be disassembled from the mist blower before to
continue
treatments.
 Please keep all parts removed from the mist blower, for an eventual re-
conversion of the machine.
 For the conversion of your mist blower MB90 / AT900 from powder
and granular to liquids, follow the procedure here below, in reverse order.
9
8
Picture 2 MB90 / AT900 complete
GRANULAR TREATMENTS
empty tanks
to the cleaning
the installation of the kit for powder and granular
2
1
4-5
Kit for treatments with powders and granulars
(liquid or
operations
Read and proceed as follow to
install the conversion kit for powder
/ granular for the mist blower model
MB90 / AT900.
Please identify in the picture 2 on
the left the areas of ntervention
associated with the number of
the operation to be performed.
3
6-7
21
powder/granular). Clean
described on the