Using Your Projector; Turning Your Projector On; Turning Your Projector Off; Adjusting The Projector Focus - Optoma PT100 Guide De L'utilisateur

Turning Your Projector ON

NOTE : Turn ON the projector before you turn ON the image source.
1. Connect the Composite Video Cable, or VGA Cable into the projector.
2. Connect Composite Video Cable, or VGA Cable to the image sources.
3. Press the POWER ON/OFF Button (see "Using Your Projector" on page 8 to locate the POWER
ON/OFF Button).
4. Turn ON your image source (computer, DVD player, etc.).
5. If the source is different from the previously used source, please use the SOURCE Button to
choose the source you would like to display.
(Note: DLP Projector factory default selection is composite video source).
If a Composite Video or PC VGA "Source not found" message appears on the screen, ensure that
the appropriate cables are securely connected.
If you have multiple image sources connected to the projector, press the SOURCE Button on the
control panel to select the desired image source.

Turning Your Projector OFF

NOTE : Unplug the projector after properly shutting down as explained in the following proce-
dure.
1. Press the POWER ON/OFF Button.
2. The cooling fans continue to operate for a few seconds.
3. Disconnect the AC Adapter.
4. Disconnect any Composite Video or PC VGA Input Cables from the projector.

Adjusting the Projector Focus

1. Rotate the Focus Ring until the image is clear. The projector focuses at distances ranging
between 24" to 144" (60 cm to 366 cm).
2. Move the projector forward or backward to zoom in and out.
1. Focus Ring

USING YOUR PROJECTOR

GB-6