Publicité
Les langues disponibles
Les langues disponibles
NOTE:
•If the Auto ACK function in "DSC Settings" is set to "Auto", the Position Reply is automatically sent to the
calling station.
•However, even if the Auto ACK function is set to "Manual", after receiving a Distress Acknowledgement,
or while in the Distress Cancel call procedure, the Position Reply is automatically sent to the calling station.
◆Sending a Position Reply Call
Send a Position Reply call when a Position Request call is received. If the Auto ACK function in "DSC
Settings" is set to "Auto", the Acknowledgement is automatically sent to the calling station.
1. While a Position Request call is being received, press softkey [
the alarm.
2. Press softkey [
], the received call's information is displayed.
3. Press softkey[
send an "Unable to Comply" Acknowledgement.
NOTE: If no valid GPS position is received, you can manually enter the position and time in "Position"
item on this screen. See "Entering the position and time" for details.
4. Press softkey [
5. Press softkey [
■Test Call
You should avoid testing calls on the specific DSC distress channels and safety calling channels. When
you cannot avoid testing on a distress or safety channel, you should indicate that these are test calls.
] to send an "Able to Comply" Acknowledgement, or press softkey [
] to send the Position Reply call.
], and then press [
] to return to the operating screen.
81
] to turn OFF
] to
Publicité
