Publicité
Drill 3.7 mm (0.15 in) hole
for fixing screws,
in 4 positions
Flush mounting:
Drill hole, Ø 11.5 mm
(0.52 in) in 4 positions
• For products supplied with self-tapping screws, drill one pilot hole only and then use one of the provided screws to test the mounting surface. Ensure that when the screw is fully inserted, it is tight and secure and does not move in any direction. Once confident that you have selected a
• For products supplied with bolts, drill one pilot hole only and then select a suitable drill bit size for the mounting surface material and thickness. If in doubt, use a smaller drill bit size than is indicated by the mounting hole or bolt size. Drill out the pilot hole in one position only, then use one of
the provided bolts to test the mounting surface. Ensure that when the bolt is fully inserted, it is tight and secure and does not move in any direction. Once you are confident that you have selected a suitable drill bit size and type, drill the remaining holes.
NOTE: This document may NOT print true to scale. Before modifying
mounting surface, ensure printed template matches the measurements
provided.
Axiom 2 Pro 9 Flush / Surface Mount Template
Surface mount
Remove material from shaded area.
Flush mount
1. Ensure sufficient thickness will remain
after rebating to secure the MFD.
2. Remove material from shaded area.
3. Rebate hatched area to a depth
of 15.00 mm (0.59 in).
Surface mounting:
Drill hole, Ø 33 mm (1.3 in)
in 4 positions
• Before drilling or cutting any holes in your vessel, ensure that you read the detailed Installation instructions provided with your product, as well as the guidance provided below:
• Always select a drill bit type (for holes) or saw type (for cut-outs) which is suitable for the mounting surface material and thickness.
suitable drill bit size and type, drill the remaining pilot holes.
• Always use any supplied washers or other additional fixing hardware supplied with the product.
UP
Axiom 2 Pro 9 Flush /
Surface Mount Template
Surface mount cut out 283.5 mm (11.16 in)
Actual unit 299.3 mm (11.6 in)
Flush mount rebate 301.3 mm (11.86 in)
Fixing holes 285.5 mm (11.2 in) apart
Surface mount suncover 306.00 mm (12.0 in)
• Do NOT overtighten screws or bolts.
Document number: 87429-1
Document date: 03-2022
Publicité
