To Recharge The Battery - Dogtra YS 300 Mode D'emploi

TESTING
2. Test by scratching the rough surface of the test
tool on the collar (as shown in the diagram) using
a coin. The collar will emit a vibration three
times. Then repeat the same process if you want
to try it again.
When the Anti-Bark Collar emits a vibration,
a stimulation is not emitted at the same time.
When you set the dial on the TEST Level,
it may be sensitive enough that the
Anti-Bark Collar can be activated easily by a
small sound or tap.
38

TO RECHARGE THE BATTERY

TO RECHARGE THE BATTERY
1. Open the Battery Charging Receptacle & Rubber
Plug on the Anti-Bark Collar and connect the
Lithium Polymer Charger to the battery-charging
receptacle as shown in the diagram.
2. Plug the Lithium Polymer Charger into an
electrical power outlet of ordinary household
voltage (220V).
3. Li-Polymer Battery provides a 2-hour rapid charge.
220-Volt Charger
Wall Outlet
39