How To Change The Battery - Dogtra 4500 Edge Notice D'utilisation

15. HOW TO CHANGE THE BATTERY

The Dogtra 4500 EDGE batteries are user replaceable.
To replace the battery in the transmitter, follow the instructions below.
1. Begin with the transmitter turned off.
2. Unscrew the two Phillips head screws attached to the back of the belt
clip and remove the belt clip. – (1)
* Unscrew the screws with a firm grip, taking extra caution to not strip
the screws.
3. Unscrew the two screws on the back of the transmitter. – (2)
* Unscrew the screws with a firm grip, taking extra caution to not strip
the screws.
4. Holding the battery wire, detach the wire from the battery connector
plug(see picture).
5. Holding the battery wire of the new battery, plug the wire in to the
battery connector plug.
* Attention : The battery wire plug in is indented to fit in one way to
the connector.
6. Check that the battery connector wire is firmly inserted into the plug.
The battery wires must be inside the battery compartment tucked
neatly along the right side of the battery.
58
(1)
(2)
* Caution - The battery wires must
be inside the battery compartment
tucked neatly along the right side
of the battery.
7. Fasten the battery cover and the belt clip back on the transmitter with
the four screws.
* Caution - Do not detach the
wire by pulling from the battery.
* Caution - The orange rubber
gasket is important for the unit
to be waterproof and must be
properly seated in place.
59