How To Attach The Belt Clip On The Arc1200S; How To Use The Test Light - Dogtra ARC 1200S Guide D'utilisation

rheostat intensity dial, the level on the screen may not change
but the actual intensity from the receiver/collar will change in
agreement with the dial. In this situation, it is ideal to either
wait until your transmitter is back to working order before
emitting a correction, or while holding the constant button
down slowly turn the Rheostat Intensity Dial while watching
your dog's reaction. Do not turn the Rheostat Intensity Dial at
a rapid increase because the receiver/collar will emit a static
correction based on the level of the Rheostat Intensity Dial,
9. HOW TO ATTACH THE BELT CLIP ON THE
ARC1200S
To attach the included belt clip to the transmitter, follow
the instructions below.
1. Align the belt clip to the grooves on the back of the
transmitter.
Philips head screws.
Caution!
50

10. HOW TO USE THE TEST LIGHT

1. Turn on the receiver/collar and place the test light over
the contact points as shown in the diagram.
2. The test light will illuminate momentarily when the Nick
stimulation button is pressed on the transmitter. The light
will stay lit as long as the Constant button is pressed on
the transmitter, up to 12 seconds.
3. When the stimulation is increased, the test light will emit
a brighter light.
51