Hilti WSR 36-A Mode D'emploi page 24

Status
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
3.5 Items supplied
Reciprocating saw, saw blade, operating instructions.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.group
3.6 Stroke rate setting
Material to be cut
Wood
Wood containing nails
Interior finishing, drywall
Plastic
Steel
Non-ferrous metals
Aluminium
Stainless steel
4 Technical data
4.1 Reciprocating saw
Rated voltage
Weight in accordance with EPTA procedure 01
Stroke rate
Stroke
Keyless chuck for standard accessory tools
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
18 English
Meaning
The battery has overheated or is completely dis-
charged.
The power tool is overloaded or has overheated.
Suggested stroke rate settings
5-6
5-6
3-4
3-4
2-3
2-3
2-3
1
WSR 36­A
36 V
4.37 kg
0 /min ... 2,850 /min
32 mm
1/2 in
214009
*214009*