Hilti WSR 36-A Mode D'emploi page 26

3. Turn the chuck locking sleeve counterclockwise and hold it in this position.
4. Push the saw blade into the chuck from the front end of the tool.
5. Release the locking sleeve and allow it to click back and engage in its original position.
6. Grip and pull the saw blade to check that it is locked in position.
5.4 Removing the saw blade
1. Engage the transport lock.
2. Turn the chuck locking sleeve counterclockwise and hold it in this position.
3. Pull the blade forward out of the chuck.
4. Release the locking sleeve and allow it to move back to its original position.
5.5 Adjusting the contact shoe
When the contact shoe is adjusted correctly the length of the blade can be used optimally and access
in corners is improved. The contact shoe engages in click-stop increments of 6 mm (¹⁵/₆₄").
Do not adjust the contact shoe while the power tool is in operation.
1. Engage the transport lock.
2. Remove the saw blade.
3. Press the contact shoe adjustment button and hold it in this position.
4. Slide the contact shoe to the desired position.
5. Release the contact shoe adjustment button.
6. Grip and pull the contact shoe to check that it is locked in position.
5.6 Adjusting the stroke rate
Please refer to the application table for the recommended stroke rate settings.
1. Set the stroke rate to a setting between 1 (low) and 6 (high) by turning the stroke rate regulator.
2. Press the control switch.
The power tool will then run at the preselected stroke rate.
5.7 Pipe-cutting adapter (accessory)
1. Engage the transport lock.
2. Remove the saw blade.
3. Press the contact shoe adjustment button and hold it in this position.
4. Pull the contact shoe forward, away from the power tool.
5. Push the pipe-cutting adapter onto the front end of the power tool and bring it into the desired position.
6. Release the contact shoe adjustment button.
7. Grip and pull the pipe-cutting adapter to check that it is locked in position.
8. Release the screw clamp on the pipe-cutting adapter fully.
9. Place the chain around the pipe and hook it back onto the pipe-cutting adapter.
The clamping screw should lie at an angle of 45° to the power tool.
10. Close the clamping screw.
5.8 Inserting the battery
CAUTION
Risk of short circuit !
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
20 English
5
6
7
8
214009
*214009*