Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance and Adjustments
We recommend contacting an authorized service dealer for all
maintenance, adjustments, and servicing of the unit. Some
routine maintenance tasks can be performed by the owner.
Refer to the maintenance schedule and procedures that follow.
CAUTION
All the components used to build this product must remain in
place for proper operation. Replacement parts must be of the
same design and installed in the same position as the original
parts. Other parts may not perform as well, may damage the
unit, and may result in injury.
WARNING
This snowthrower must be properly maintained to ensure safe
operation and performance. Failure to observe the safety
instructions in this manual could result in death or serious
injury.
• Before performing any maintenance or repairs on the
snowthrower, shut OFF the engine and remove the ignition
key or the push/pull key.
Maintenance Schedule
First 5 Hours
Change Oil
Before Each Use
•
Check engine oil
•
Check auger and impeller stop time
After Each Use
Remove accumulated snow and slush to prevent freezing of the controls,
wheels, discharge chute, and auger
Every 25 Hours or Annually
•
Change engine oil
•
Check tire pressure
•
Check auger adjustment
•
Lubricate control lever linkage
•
Lubricate the discharge chute and deflector
•
Lubricate the auger assembly
•
Lubricate the hex shaft and gear
•
Lubricate the drive wheel axles
•
Check muffler and spark arrestor (if equipped)
•
Clean, gap, or replace sparkplug (dealer service)
•
Check valve clearance (dealer service)
1
Not required unless engine performanance problems are
noted.
Emissions Control
Maintenance, replacement, or repair of the emissions control
devices and systems may be performed by any non-road engine
repair establishment or individual. However, to obtain "no
charge" emissions control service, the work must be performed
by a factory authorized dealer.
Changing the Oil
Used oil must be discarded correctly. Do not discard with
household waste. Check with your local authorities, service
center, or dealer for safe disposal or recycling facilities.
Use Briggs & Stratton Synthetic 5W-30 Warranty Certified oil
for best performance. Other high-quality detergent oils are
acceptable if classified for service SG, SH, SJ or higher. Do not
use any additives.
1. With the engine stopped but still warm, turn the ignition key
to the OFF position and remove it or pull out the push/pull
key (if equipped).
WARNING
Fuel and its vapors are extremely flammable, which could
cause burns or fire that result in death or serious injury.
• During maintenance, the fuel tank must be empty or
fuel can leak out and result in a fire or explosion.
2. Remove the oil drain plug (D, Figure 18). Carefully tilt the
snowthrower and drain the oil into a container.
3. Install and tighten the oil drain plug (D).
1
15
Publicité
Table des Matières
