Simplicity Signature Pro Serie Manuel De L'utilisateur page 11

7
Adjusting the Chute Deflector
Chute Deflector Switch
When the engine is ON press either side of the chute deflector
switch (A, Figure 8) up or down to raise and lower the deflector
(B). Raise the deflector to throw snow further. Lower the
deflector to throw snow closer.
8
Engaging the Auger and Impeller
The auger and impeller works together to break up the snow
as the snowthrower moves forward and throws it out the
discharge chute.
DANGER
The snowthrower contains a rotating auger and impeller that
throws snow. Fingers or feet can quickly become caught in
the rotating auger or impeller and result in traumatic
amputation or severe laceration.
1. Press and hold down the auger control (A, Figure 9) lever
on the right handle to engage the auger and impeller.
9
2. Release the auger control to disengage the auger and
impeller. The auger and impeller must stop within 5 seconds
after the auger control is released. If it does not stop:
• Adjust the control cable. See Adjusting the Auger
Control Cable .
• If the auger still does not stop within 5 seconds, see an
authorized dealer.
Engaging the Drive Wheels
NOTICE Do not move the speed select control while the
traction control is engaged. This can result in damage to the
drive system.
1. To drive forward, move the speed select control (A, Figure
10) to one of the forward positions. Set the speed control
to a lower number for heavy snow, a middle number for
light snow, and a higher number to move snow without snow
removal.
2. Press and hold down the traction control (B) lever on the
left handle.
11