Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B
Using the appliance
WARNING
This appliance must be earthed. The manufacturer declines
all liability in the event of non-compliance with these safety
measures.
Operation
Removable shelves/trays
•
Your appliance is equipped with various glass or plastic storage shelves or wire trays. Different
models offer different combinations and comprise different features.
• The refrigerator walls are fitted with a series of guides so that the shelves can be positioned
as required.
Removing the door shelf
3
Pull the left side of the door shelf, press the other side towards the inside and raise this
side until it dislodges from the casing. You can then remove the door shelf from the casing.
Installing the door shelf
Install the left side of the door shelf first.
4
Then push the other side inwards and press on this side until it is installed.
Crisper
Used to store fruits and vegetables.
Used to store food that does not need to be frozen. It is divided into different sections for different
types of food.
8
EN
B
Using the appliance
Reversing the door
The direction in which the door opens can be changed from right (as per delivery) to left to
suit the installation position. Necessary tools:
A screwdriver with 1.8 mm sleeve
Cross-headed screwdriver
Putty knife or thin, flat screwdriver
Lay the refrigerator on its back before your start so that you can access the base. You should
place it on its soft foam packaging or similar materials to prevent the cooling pipes at the
back of the refrigerator from being damaged.
Reversing the door
6
Position the refrigerator vertically, remove the two screws at the back of the top cover, raise
the top cover and place it on a soft surface to prevent scratching.
7
Remove the four screws as illustrated in the diagram below. Lift the hinge plate off the upper
hinge and keep it in a safe place.
8
Lift off the door and place it on a padded surface to prevent scratching. Remove the two
adjustable feet, then remove the lower hinge support by loosening the nuts. Move them to
another side.
Place the door in its new position ensuring that the stud is inserted in the ring located in
9
the lower frame section. Replace the cover by fitting the hinge plate of the upper hinge into
the opening in the upper door and attach firmly using the
on the other side.
Place the upper cover on the freezer. Tighten the 2 screws at the
10
WARNING
The appliance must not be plugged into the mains when
changing the direction in which the door opens. Remove the
plug from the mains socket beforehand.
2 screws. Replace 2 more screws
back of the upper cover.
9
EN
Publicité
Table des Matières
