Installation Procedure - Kenwood DMX9720XDS Guide De Démarrage Rapide

• Do not press hard on the panel surface when
installing the unit to the vehicle. Otherwise
scars, damage, or failure may result.
• Reception may drop if there are metal objects
near the Bluetooth antenna.
Bluetooth/Wi-Fi antenna unit
Ñ

Installation procedure

1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Remove the vehicle parts for installing the
unit and connecting wires to terminal.
3) Make the proper input and output wire
connections for each unit.
4) Determine the height of the display unit and
position of the slider. See Distance between
the display unit and the main unit (P.14).
5) Take Connector B on the wiring harness and
connect it to the speaker connector in your
vehicle.
6) Take Connector A on the wiring harness and
connect it to the external power connector
on your vehicle.
7) Connect the wiring harness connector to the
unit.
8) Install the main unit to the vehicle.
9) Reinstall the vehicle parts.
10) Install the display unit.
11) Reconnect the ¤ terminal of the battery.
12) Perform the Initial Setup.
See Initial SETUP (P.6) in the Instruction
Manual.
● Forward and Lateral Fields of Vision
• To determine driver's forward and lateral fields
of vision under normal conditions, place a
pole (directly visible from the front or visible
through the car rear-view mirror) as shown.
*
1
1 m 0.7 m 0.9 m
0.3 m
2 m
[ ]: Pole (height: 1m, diameter: 0.3m)
[ ]: Field of vision from steering position
[ ]: Exempted area (pole size is subject to
regulation)
• For right hand drive vehicles, standards are
reversed.
*1 The pole must be visible from the driver's position as
direct forward field of vision.
*2 The pole must be directly visible or indirectly visible
through the mirror, etc. from the driver's position.
Ñ
Supplied accessories for
installation
1
x1
2
x1
3
(3 m)
x1
4
(M5 x 8 mm)
x6
5
(M5 x 8 mm)
x6
6
(3.5 m)
x1
7
x1
Connection/Installation
*
2
0.3 m
2 m
0.3 m
8
x1
9
x2
0
Left/Right x1
-
(M5 x 8 mm)
x6
=
x1
~
(Ø3 x 6 mm)
(Black)
x2
English
13