User Modes; Flexion Lock Mode; Cycling Mode - Blatchford Orion3 Guide De L'utilisateur

7 User Modes

The device has 2 User Modes. Please note that these modes are only available if they have been
enabled by your practitioner.
Warning:
Care must be taken to only use those modes as instructed by your practitioner.
1 Flexion Lock
Sets the limit of flexion to a predetermined angle.
The maximum lock angle is 45 degrees from fully extended.
2 Cycling (Free swing)
Releases stance resistance, the device will then swing freely.
Warning:
In Cycling mode there is no stance control active, this mode must be deactivated before
resuming walking to avoid falling and possible injury.

Flexion Lock mode

User activation of Flexion Lock mode with
To activate Flexion Lock:
Fully extend the knee.
Press the button 3 times, a short beep confirms each button press, 3 short beeps confirm that
Flexion Lock is ON.
To deactivate Flexion Lock:
Press and hold you will hear 2 long beeps.
WARNING: After exiting Flexion Lock Mode, always test/ confirm that the device is
operating normally again before walking.

Cycling mode

Warning:
In Cycling (free swing) mode there is NO stance resistance.
User activation of Cycling mode with
To activate Cycling mode:
Press the button 4 times, a short beep confirms each button press, 4 short beeps confirm that
Cycling mode is activated.
To de-activate Cycling mode:
Press and hold you will hear 2 long beeps.
WARNING: After exiting Cycling Mode, always test/confirm that the device is
operating normally again before walking.
button on the device
button on the device
11
938375/6-0520