Certification - MEDC XB10 Manuel Technique

To replace the cover use the same procedure as above but in reverse manner, ensuring that the cover is screwed
tightly, ensuring IP67 rating is maintained.

4.0 CERTIFICATION

Certified to EN50014:1998,
EN50018:1995 &
EN 50019:2000
EExd Unit(ATEX Certification No.
BAS 00ATEX2204X): -
15J: - II2G EExd IIB T4
(Tamb. –55° C to +40°C)
10J: - II2G EExd IIB T4
(Tamb. –55°C to +55°C)
EExde Unit (ATEX Certification No. BAS 00ATEX2226X):
15J: II2G EExde IIB T4
(Tamb. –50°C to +40°C)
10J: II2G EExde IIB T4
(Tamb. –50°C to +45°C)
The ATEX certificate and the product label carry the ATEX group and category marking: -
II 2 G
Where: -
signifies compliance with ATEX
II signifies suitability for use in surface industries
2 signifies suitability for use in a Zone 1 area
G signifies suitability for use in the presence of gases
5.0 APPROVALS
Electromagnetic compatibility to BS EN 50081-1:1992
BS EN 61000-6-2:1999
6.0 SPECIAL CONDITIONS FOR SAFE USE
a) Certificate Number
BAS00ATEX2204X (EExd)
1) The mating thread of any cable entry device used with this apparatus must exceed 12mm in length.
2) Painting and surface finishes, other than those applied by the manufacturer, are not permitted.
b) Certificate Number BAS00ATEX2226X (EExde)
1) Not more than one single or multiple strand lead shall be connected into either side of any terminal, unless
multiple conductors have been joined in a suitable manner, e.g. two conductors into a single insulated crimped
boot lace ferrule.
2) Leads connect to the terminal shall be insulated for the appropriate voltage and this insulation shall extend
to within 1mm of the metal of the terminal throat.
3) All terminals screws, used and unused, shall be tightened down.
4) Minimum creepage and clearance distances between the terminals and adjacent conductive parts (including
cable entry devices) must be at least 5mm.
5) Painting and surface finishes, other than those applied by the manufacturer, are not permitted.
© MEDC 2003 04/09